Motion Control Cards

Products Menu
Display:
List
Grid
Show:
Sort By:
MESA 7i29 Dual 2KW H-bridge for 4i27 and FPGA cards
The 7I29 is 2 channel H-bridge motor drivers for the 4I27 or FPGA based motor controller cards. The 7I29 connects to the motor controller card with a 50 conductor flat cable and have screw terminals for motor power and motor connections. Two 7I29's can share a 4 Axis 50 conductor cable to FPGA controller.  Encoder and index input connectors are also made available on the 7I29. Encoder inputs ..
291.04€

Availability:
Pre-Order

MESA 7i39-HV Dual 250W 3 Phase BLDC driver
The 7I39 is a Dual 3 Phase bridge driver for Brushless 3 phase motors.  The 7I39 is available in low voltage and high voltage models.  The low voltage model is rated at 10A 30 VDC per axis while the high voltage model is rated at 5A 50 VDC per axis.  Each 3 Phase bridge on the 7I39 has selectable overcurrent limits of .75 times and 1.5 times rated current.  An overvoltage clamp..
144.81€

Availability:
Pre-Order

MESA 7i39-LV Dual 250W 3 Phase BLDC driver
The 7I39 is a Dual 3 Phase bridge driver for Brushless 3 phase motors.  The 7I39 is available in low voltage and high voltage models.  The low voltage model is rated at 10A 30 VDC per axis while the high voltage model is rated at 5A 50 VDC per axis.  Each 3 Phase bridge on the 7I39 has selectable overcurrent limits of .75 times and 1.5 times rated current.  An overvoltage clamp..
144.81€

Availability:
Pre-Order

MESA 8i20 2200W 3 Phase Amplifier
The 8I20 is a low cost 2200W 400V three phase torque mode amplifier for synchronous permanent magnet servo motors (Brushless AC servo) up to approximately 3HP.  The 8I20 will supply peak currents of 30A.  High side logic and gate power are derived from the low side allowing a wide operational bus voltage range (24 to 400VDC) and host communication when bus voltage is off.  Low side ..
232.83€

Availability:
Pre-Order

MESA THCAD-10 High isolation A-D accessory
The THCAD is a frequency to voltage converter type A-D designed for high noise environments like plasma voltage monitoring for torch height controls.  The THCAD is available in two voltage ranges, 0-10V and 0-300V.  When used for plasma voltage monitoring, the 10V version requires an external high voltage resistor. The advantage of the 10V THCAD and external resistor is that the resistor..
66.73€

Availability:
15 Un.

MESA THCAD-300 High isolation A-D accessory
The THCAD is a frequency to voltage converter type A-D designed for high noise environments like plasma voltage monitoring for torch height controls.  The THCAD is available in two voltage ranges, 0-10V and 0-300V.  When used for plasma voltage monitoring, the 10V version requires an external high voltage resistor. The advantage of the 10V THCAD and external resistor is that the resistor..
66.73€

Availability:
6 Un.